| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-25-2008, 02:58 AM
| |||
| |||
I have a tc22 and a tc30, both experience nvram errors randomly during long 3d cuts. Any advice on eliminating these problems? Terrible thing about this prob is that it drops the ram about .050" when it occurs, not good on finish passes! thx guys.  |
|
#2
05-25-2008, 10:40 AM
| |||
| |||
| Long 3D cuts require a data stream from the hard drive, through the mother board to the BMDC. How old is the hard drive? Last defrag and scandisk? Or are you using flash memory? They have limited read/write life. Does your mother board have a heat sink on the processor or a heat sink/fan assembly? Have you checked your logic power supply voltage and fan? Heat could play a factor here. Have you cleaned and reseated your BMDC board? Tried a different ISA slot if available? How is the air filter on the back cabinet? Z drop may be due to time lag between drives dropping out and Z brake engaging. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tl-2 program integrity error and program data error alarm #'s 212 250 need help | CNChelp | Haas Mills | 12 | 03-14-2010 08:19 PM |
| OM-A ROM PARITY ERROR "NOT RAM ERROR" | offroadxx | Fanuc | 9 | 05-07-2008 08:15 PM |
| G71 error | 1ctoolfool | Haas Mills | 10 | 10-02-2007 08:01 PM |
| Error #17 | j-radkemachine | Fadal | 1 | 07-08-2006 11:16 AM |
| | |
Linear Mode
