TNC.151 ISO to Heiden. dialog - CNCzone.com-The Largest Machinist Community on the net!

Jurek · #1 05-22-2008, 10:10 PM

How to switch TNC151 from ISO to conversational./ Whitch Parameter,#/. Thanks Jurek.

gus · #2 05-23-2008, 05:10 PM

isn't it in the user parameters, or under the mod key?

gridley51 · #3 05-23-2008, 06:40 PM

It`s Machine parameter 217,set to 1 for ISO, 0 for Heidenhain.

mwibbels · #4 05-16-2009, 06:37 PM

Gus is right - the switch for the language should be under the user parameters - if it doesn't show up there you might want to put a P after the value in MP217 (using the polar key) the next time you go into the MP list - it is a safer and faster to select the language from the user parameters list.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
On Dialog 11 3D program jerking	m.amir	Deckel, Maho, Aciera, Abene Mills	0	02-24-2007 07:03 AM
Too many dialog boxes...	mdlweb	OneCNC	3	11-07-2006 10:40 AM
Confirm Dialog ?	Rance	Alibre Design	2	12-22-2005 06:21 AM
dialog box	pminmo	Suggestions for the CNCzone.com site.	1	08-03-2004 07:08 AM
Dialog Digits	MikeT	BobCad-Cam	2	03-02-2004 08:07 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)