hardinge vmc1000

[samu]

I need to change the rubber seal on each segment of the axis cover plate on a vmc 1000 but i dont know where i could find this kind of seal.
Anybody know?

[MauserBob]

We have two of these in our shop and both of them have had near-catastrophic y-axis way-cover failures at least twice. Had to order new way-cover sets to get the seals replaced, and had to call Hardinge to get 'em. Can't remember price, seems like it was over $1k at a shot for the whole x-y axis set. On the third failure on one of the two machines, we finally had enough and ripped 'em off and replaced the whole shebang with a custom-fit rubber sheet to protect the y-axis, and let the x-axis covers beat themselves to death. We are machining plastic dry with high pressure air blast for chip clearance so it's not as much of a problem as if we were running coolant in a metal machine.....anyway, to cut to the chase, give Hardinge a call. Don't have the # handy, sorry about that, but somebody else here must have it. Hope you get it sorted out...just be prepared to do this repair again.


Rob.

[moldxman]

vmc1000
Ive goten parts through a yang dealer in Orange ,Ca 92868

[donnelson]

i just buought one also, am trying to get it up and running it has a siemens control 810 d i am sure having lots of trouble figuring out how it likes everything, now trying to figure out how to dnc to control any thoughts

[Manuel Vargas]

I need a tool magazine for a Hardinge machine center VMC1000, can someone help me find it please?

[samu]

Did you try to call hardinge, They stop selling replacement part via their web site shophardinge.com but if you send a request, they will help you, i've bought some part directly from hardinge since they close theire online shop. You could also find a lot of independent dealer that charge you until twice the price that hardinge charge

[Manuel Vargas]

Did you try to call hardinge, They stop selling replacement part via their web site shophardinge.com but if you send a request, they will help you, i've bought some part directly from hardinge since they close theire online shop. You could also find a lot of independent dealer that charge you until twice the price that hardinge charge

Thank you I guess I got a bit ancient, I found a distributor in Houston willing to help.