412 interact tool page

[windy]

Evening all.

finally got the Interact 412 going and happy running the programmes for general info that are in there, apart from now I want to do my own stuff I cant find the tool page.
theoretically this should be programme 0. At work on our 600 we use programme TOOL but I dont have a qwerty keyboard on the 412.

looking thru the manual I have (think its a 350) against my system same apart fromm not having graphics, can anyone tell me how I get the tool page?
Im led to believe its part protected by a code, weve tried the code but cant get the page required up.

any help appreciated, I can fill in system blanks and code numbers tomorow.

[windy]

actually a 351 operating system and Heidenhain UK have given me parameter mumber to use but manual does not clearly state how to change.
type in code 86357 then 225

but after pressing mod key and cursor down do I have to unlock protection 0 to 1 before adjusting or is that just for programme protection?

which buttons do I need to press after code number insertion? ent? end?
thanks

[windy]

anyone know??

[kdhBOSS5VRAM]

Hi,
We have an older 720 and Interact 1 at work with I think the same control but we never had a tool page. We always entered offset and radius in the program in the tool call, tool def. line. I have seen it done on a similar machine with the tool page but have never done it like that. I'd have to look tomorrow about entering the code but I thought you just press end. I don't think it will mess anything up if you hit the wrong button.

Kevin

[RMARCH]

Originally Posted by windy actually a 351 operating system and Heidenhain UK have given me parameter mumber to use but manual does not clearly state how to change. type in code 86357 then 225 but after pressing mod key and cursor down do I have to unlock protection 0 to 1 before adjusting or is that just for programme protection? which buttons do I need to press after code number insertion? ent? end? thanks

Press ENTER

[windy]

thanks