| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-15-2008, 05:40 PM
| |||
| |||
All, This is a very basic question, but I have no clue. I have every manual for the Series II CNC I own, but the operators manual, and I can not figure out how to set my tool lenghts. Could some one give me an idiots guide on how to set the tool lengths please?  |
|
#2
03-21-2008, 01:33 AM
| |||
| |||
| sent you a PM with my number....call me and I'll walk you through it while your at the machine. Edit........I'm on left coast time. |
|
#3
04-06-2008, 07:53 PM
| |||
| |||
| Dave, Thanks again for the help!! |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help! Dnc setting for Mitsubishi 500 series | koeitool | Mazak, Mitsubishi, Mazatrol | 3 | 08-09-2007 07:45 AM |
| Setting up a Tool Setter. | Smackre | Mach Software (ArtSoft software) | 6 | 06-16-2006 10:41 PM |
| Boss 6 series 1 | creep_pea | Bridgeport and Hardinge Mills | 35 | 11-03-2005 04:07 PM |
| Parallet and Series transformer Setting problem | weberluk | General Electronics Discussion | 5 | 10-17-2005 11:17 PM |
| | |
Linear Mode
