Help Tnc 2500 - CNCzone.com-The Largest Machinist Community on the net!

opa3279 · #1 02-24-2008, 12:53 AM

I purchased a Interact 1020 Bridgeport mill a few years back.
It was missing the keyboard & monitor console. I sure would like to get
it up & running. The mill is the same as a Interact 720 but larger I think.
If anyone has any info.I sure would appericate any it.

thanks opa3279

gus · #2 02-24-2008, 06:55 AM

I think that is the control, am I wrong on that?

opa3279 · #3 02-24-2008, 11:09 AM

What I understand this console plugs into cables on the mill. The console is on casters
where you can roll it around. All control boards are in the mill elect. panel.
thanks opa3279

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gerber DCS 2500 Cutter	Micro Rotors	Printing, Scanners, Vinyl cutting and Plotters	1	04-02-2008 03:32 PM
heidenhain tnc 2500	blackpalm	Bridgeport and Hardinge Mills	28	11-22-2007 10:26 AM
TNC 2500 Z axis delay	Allform	Bridgeport and Hardinge Mills	3	10-24-2007 10:23 AM
heidenhain tnc 2500 controller	blackpalm	Bridgeport and Hardinge Mills	2	09-21-2007 09:20 AM
Heidenhain 2500	nycooh	General CNC (Mill and Lathe) Control Software (NC)	0	08-17-2007 03:57 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)