| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-29-2008, 11:30 AM
| |||
| |||
hey guys, i recently purchased a bridgeport series II boss 6 retro-fitted with the ahha / machine master pc control .. after powering up the machine I can turn on the spindle and ramp up the rpm's but i cant jog the axis's ... the numbers on the monitor say its moving but none of the axis's actualy move .. i manualy triggered the limit switch and the control does see that... ive checked all the fuses and the seem to be fine .. unless theres a fuse hidden somewhere that i didnt see ..... anyone have any idea what could be going on with my machine ??? any help is greatly appreiciated    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| board wont move steppers | guido_kp | Hobbycnc (Products) | 4 | 05-22-2007 05:19 PM |
| Cent.4 wont read I or J help | Jeff S | Milltronics | 4 | 03-30-2007 02:35 PM |
| Why wont this work????? | epineh | General Electronics Discussion | 7 | 03-18-2007 01:44 AM |
| mach 2 wont run | pbmann123 | Mach Software (ArtSoft software) | 1 | 08-23-2005 04:42 AM |
| The X-Axles... to move or not to move! | Wild4aces | Mechanical Calculations/Engineering Design | 1 | 03-18-2005 02:26 PM |
| | |
Linear Mode
