| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
01-29-2008, 08:46 PM
| |||
| |||
| That is BMDCPRMS.SYS and if you have your back up disk, it is probably on it. Still the orient and tool change height may need to be set as well as other parameters. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bridgeport torq cut-22 problems!! | baystard | Bridgeport and Hardinge Mills | 15 | 01-17-2008 02:22 PM |
| bridgeport torq cut 30 software | jaimeeduardo | Bridgeport and Hardinge Mills | 9 | 09-25-2007 10:52 PM |
| DX-32 questions about programming, etc (Torq Cut 22) | vettespeed | Bridgeport and Hardinge Mills | 7 | 02-06-2007 06:37 PM |
| Bridgeport Torq-Cut 2G-????? | bherr | Bridgeport and Hardinge Mills | 17 | 10-21-2006 01:56 AM |
| Bridgeport Torq Cut 22: What lubricants? Where? How? | vettespeed | Bridgeport and Hardinge Mills | 5 | 06-24-2006 02:38 PM |
| | |
Linear Mode
