| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-22-2008, 03:54 AM
| |||
| |||
Have been trying to establish the connection betweeen my laptop and my tnc 370 with no success. Settings I am using on tncremont are serial connection, com3 and automatic baud rate. Then i have the nc set into EXT mode. Simply cannot get a connection established. Has anyone any ideas of what i may be doing wrong? Thanks in advance,    |
|
#2
01-24-2008, 07:00 AM
| |||
| |||
| hi mate i had a few hassels when i tried conecting my laptop to my bridgeport with heidenhain 2500 control im not sure about your control but i know the cable conection was very important along with a few parrameter changes regards greg |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Connecting rod | ACME | I.C. Engines | 18 | 08-11-2007 01:09 PM |
| Connecting Gantry | droddis | DIY-CNC Router Table Machines | 0 | 07-06-2007 07:06 PM |
| connecting two cnc routers to one pc | ctyler | Machine Problems, Solutions , Wireless DNC, serial port | 6 | 02-23-2007 12:09 PM |
| connecting | KrashKing405 | Open Source Controller Boards | 18 | 07-26-2006 06:30 PM |
| Need help connecting laptop to CNC | flyguy1254 | General Metal Working Machines | 1 | 10-20-2004 07:28 PM |
| | |
Linear Mode
