| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-19-2008, 11:00 AM
| |||
| |||
Everything on this machine works execpt spindle enable. I know that spindle forward or reverse switch must be activated at same timeas spindle enable button. I can ground the contactor coil & spindle will run. the enable button goes tocircuit boards dps,fmdc2,salf and on to contactor. What I don't how to do is check signal path or know what to look for. Somehow not getting ground to contactor. Hope some can help. thanks so much. The way oil switch checks out OK & overload is not triped, or defective Minnesota hd10 Last edited by Minnesota HD 10; 01-20-2008 at 09:17 AM.    |
|
#2
01-19-2008, 11:32 AM
| |||
| |||
| The 2 most common reasons that a spindle will not start are: Way oil level too low or bad float switch. The overload for the spindle is tripped. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Boss 5 spindle switch problem | DaveinUK | Bridgeport and Hardinge Mills | 8 | 04-05-2011 02:07 AM |
| Boss 5 series 1 BP, spindle wont start | signweld | Bridgeport and Hardinge Mills | 3 | 11-16-2006 07:21 PM |
| BP - BOSS 4, Where to start? | camerons | Bridgeport and Hardinge Mills | 5 | 07-14-2006 04:48 PM |
| Boss keeps tripping out on start up | creep_pea | Bridgeport and Hardinge Mills | 4 | 09-30-2005 04:12 PM |
| spindle electrical noise | balsaman | General Electronics Discussion | 9 | 10-21-2003 09:41 PM |
| | |
spindle start electrical problem boss 10 bp 
Linear Mode
