Torqcut 22 computer - CNCzone.com-The Largest Machinist Community on the net!

gokarter · #1 01-18-2008, 03:46 PM

Can the computer be upgraded from the 486 that is in there right now?

To a pentium series computer or is the processor to fast for the rest of the machine now.

Last week the HD crapped out in it now this week the mother board gave up.

Any help or advice would be greatly appreciated

Thanks in advance
Jason

machintek · #2 01-19-2008, 11:21 AM

2 choices.
Dumpster diving.
Or call EMI and get a mother board kit, includes a half size baby pentium mother board, and a back plane for it and the BMDC to plug into. I would add a DOM (disk on a module) to replace the hard drive, and a new logic power supply.
But sit down before you hear the price.

George

gokarter · #3 01-19-2008, 12:21 PM

Thanks for the reply

Now where can I locate EMI's phone# or wed address

machintek · #4 01-20-2008, 02:21 PM

http://emi-inc.net/

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
TORQCUT 22	limey44460	Bridgeport and Hardinge Mills	4	01-11-2008 07:15 AM
TorqCut 22 - belts numbers needed?	RedGTZ	Bridgeport and Hardinge Mills	2	12-18-2006 01:18 AM
Computer Help	jamesr	Surfcam	4	08-25-2006 09:36 AM
New Computer	bill south	Computers and Networking	5	08-05-2005 12:26 PM
fast computer as server, slow computer as terminal	replicapro	Computers and Networking	1	07-01-2004 03:05 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)