12-22-2007, 06:45 PM
|
| | | Join Date: May 2007 Location: Sweden
Posts: 28
| |
BP int2 S4 Stops in programs! | |
Hi, yesterday we were milling a pressure chamber for a car, a simple operation with a CIP program. When i had run the program for about 30mins the mill stopped. It stops in the middle of the program. Not in the same place as before. On the screen it says F0 and it does´nt react when im turning on the F feedrate pot. The light ( that looks like a timeglass ( or how it now spells ) are flashing for some time and then stops, if i turn both of the pots for spindle speed and Feed rate and increases them and decreases them, the timeglass light lights up and then suddenly the d*mn machine continues with the program! If i press Em-stop and starts it up again the problem is still there, but if i shut the power switch off for a while, i can run the program much longer before it starts with the stopping again!
Does anyone have any idea what can cause this? Can i read any error message out of this blinking light on the screen?
Thanks. Oviksnc@hotmail.com
__________________
OviksNC/Sweden. |
Similar Threads 
Linear Mode
