| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-18-2007, 06:14 PM
| ||||
| ||||
Ok I am new to the Boss5 I have it loading programs from BobCad, oh by the way that was a bigger challenge than you would think it is ok now, but when I run the program it all goes to a setup such as 2.5 on XYZ then a light comes on that says wait and hold, I hit start again and the hold light goes out but not the wait light how do I get past the wait light does this have anything to do with the TLO input, or something else I have contacted a company to purchase a manual but was kind of hoping I could get past this before the weekend. thanks in advance. Last edited by frog; 12-18-2007 at 06:14 PM. Reason: Typo  |
|
#2
12-18-2007, 07:49 PM
| |||
| |||
| Just maybe you have a G1 programmed and it is waiting to see that you turned on the spindle. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Boss5 Collets | frog | Bridgeport and Hardinge Mills | 8 | 03-05-2008 10:06 AM |
| Boss5 Rs-232-Amp | frog | Bridgeport and Hardinge Mills | 4 | 12-08-2007 09:27 PM |
| Should I get 5.0 or wait for 6.0, or | fc911c | Visual Mill | 10 | 03-01-2007 09:26 AM |
| R2E3 Boss 8 Display says E!!!! WAIT | hrhoward | Bridgeport and Hardinge Mills | 1 | 09-07-2006 10:13 PM |
| Need Help Boss5 to Gecko/Mach2? | braidmeister | Bridgeport and Hardinge Mills | 29 | 01-31-2006 01:58 PM |
| | |
Linear Mode
