| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-23-2007, 11:32 AM
| |||
| |||
I need help getting a R2E4 boss 9 mill to recieve date from Bobcad cam 20v. I'm using port B baud rate of 4800 and 7 bits even parity and stop bit 1 with a boss 9 post processor. I can get it to send data one time and then it won't the next. Allows comes up error loading but will allow program to go through sometimes. I use bobcad with my motion master mill with no problem. I appreciate any help.  |
|
#2
10-23-2007, 11:43 AM
| |||
| |||
| I was told port B was for EZLINK only. Port A would accept any generic communications program. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| BridgePort Series I CNC BOSS 9 / R2E4 Problems | gbarker | Bridgeport and Hardinge Mills | 8 | 06-18-2010 05:51 AM |
| Fanuc 3t Communication Problems | stephaan | Fanuc | 2 | 11-16-2006 09:12 AM |
| R2E4 Startup problems | jeep534 | Bridgeport and Hardinge Mills | 3 | 10-24-2006 02:32 PM |
| Communication Problems | dillweed | General CNC (Mill and Lathe) Control Software (NC) | 1 | 10-18-2006 10:12 AM |
| Fadal Communication problems | sc_crasher | Fadal | 9 | 03-14-2006 11:38 AM |
| | |
Linear Mode
