Bridgeport V2E3 CNC Mill Boss 8

[kebell03]

I am troubleshooting a (1985 Bridgeport V2E3 CNC Mill Boss 8 Texttron) and I have no manuals for it. Fuse 12 in the drive power supply keeps blowing. I am trying to figure out what the fuse 12 is connected in line with and hopefully to my problem. If anyone could offer some insite into this it would be a great help.

[machintek]

I believe wire 13 feeds fuse 12 which then goes to the drive power supply.

George

[wcarrothers1]

I know this will probably not help (since I'm a boss 10) but one of my fuses (memory is fogge though) for I think the X axis drive blew when I first started playing and it was due to the jib in the table comming loose and jaming the table. Replaced fuse, freed/fixed table/jib and didn't have the problem again.

b.

[kebell03]

do you think the maintinace manual for the V2E3 will help me find out what the fuse 12 goes to. I just ordered one online.