Bridgeport V2E3 CNC Mill Boss 8 - CNCzone.com-The Largest Machinist Community on the net!

kebell03 · #1 10-17-2007, 02:31 PM

I am troubleshooting a (1985 Bridgeport V2E3 CNC Mill Boss 8 Texttron) and I have no manuals for it. Fuse 12 in the drive power supply keeps blowing. I am trying to figure out what the fuse 12 is connected in line with and hopefully to my problem. If anyone could offer some insite into this it would be a great help.

machintek · #2 10-17-2007, 07:49 PM

I believe wire 13 feeds fuse 12 which then goes to the drive power supply.

George

wcarrothers1 · #3 10-18-2007, 12:26 PM

I know this will probably not help (since I'm a boss 10) but one of my fuses (memory is fogge though) for I think the X axis drive blew when I first started playing and it was due to the jib in the table comming loose and jaming the table. Replaced fuse, freed/fixed table/jib and didn't have the problem again.

b.

kebell03 · #4 10-29-2007, 12:36 AM

do you think the maintinace manual for the V2E3 will help me find out what the fuse 12 goes to. I just ordered one online.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Trouble with a series 1 boss 8 v2e3	fireman323	Bridgeport and Hardinge Mills	2	08-27-2007 06:53 PM
YA Bridgeport BOSS capability	zcases	Yeager Automation	1	10-18-2006 10:48 AM
Bridgeport CNC Mill, Model R2E4, Boss 9 Control	Tbucit	Bridgeport and Hardinge Mills	5	03-17-2006 09:39 PM
Bridgeport R2E3 with Boss 8	John Bennett	Bridgeport and Hardinge Mills	0	09-16-2005 07:35 PM
bridgeport mill series1 boss 4?	jerid1	Bridgeport and Hardinge Mills	5	07-07-2005 06:10 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)