| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-06-2007, 01:30 AM
| |||
| |||
1. Even After Disconnecting Output(u,v,w) From Drive To Motor, When Drive Is Powered Up Then Initially I2t Led Gets On (green Led) But After Few Seconds I2t Led Gets Off Sensing Overcurrent In Drive 2. Power Section Of Drive Checked, Found Ok 3. All Control Cards Checked & Found Ok, But Still I2t Led Gets Off & Red Led Lf(logic Fault) & Ezf Get On Kindly Advice Best Regards, M. Rishikesh Jamshedpur India  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SCM Routron 921 w Bosch CC100, spindle don't start. | ramsberg | Commercial CNC Wood Routers | 1 | 02-14-2011 08:58 AM |
| Sweo spindle drive? new mill dead spindle | Shizzlemah | Fadal | 13 | 12-18-2008 11:11 AM |
| Bosch Axis Drive Board Z15-1-240V | RMARCH | Bridgeport and Hardinge Mills | 0 | 08-15-2007 12:35 PM |
| Tuning Bosch Drive cards when replacing SEM Motor | RMARCH | Bridgeport and Hardinge Mills | 1 | 03-03-2006 11:34 AM |
| Seeking advice on Bosch Rotocut as spindle | abasir | DIY-CNC Router Table Machines | 7 | 06-16-2005 03:13 AM |
| | |
Linear Mode
