| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-01-2007, 11:57 AM
| |||
| |||
Hi, We couldn't figure how to put these images in a private message, so we went ahead and posted them this way. With Machinetek's help, we think the problem we are having is with the Logic Power Supply board overheating. Bill placed a cooling fan over it, and the mill is running just fine now. Does anyone know if there is a good, used board for sale? Thanks everyone for the help so far, Bill Gillen and Tim Glover  |
|
#2
10-01-2007, 08:56 PM
| |||
| |||
| I do not know where to buy a exact replacement. You may try Ebay but all these power supplies are getting old. I would try EMI and see if they have a replacement. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where to buy a good power supply for gecko 201's | journeyonline | Gecko Drives | 1 | 04-02-2007 06:57 PM |
| Making a good use of Computer Power Supply 3.3, 5, 12, -12 Vdc. Advice needed!! | cjchands | General Electronics Discussion | 8 | 10-25-2006 06:45 AM |
| R2E4 logic power supply | jeep534 | Bridgeport and Hardinge Mills | 4 | 10-23-2006 11:43 PM |
| Where is a good place to purchase IC’s in the UK? | bob a job | General Electronics Discussion | 2 | 01-18-2005 05:06 AM |
| Where is a good place to start? | Binow | DIY-CNC Router Table Machines | 1 | 07-16-2004 02:52 PM |
| | |
Linear Mode
