| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-21-2007, 01:38 AM
| |||
| |||
on my series 11 interact 11 when I try to reference the axises I get a drive axis fault. my voltage coming out of transformer T-2 is 185 off of the 2 180 legs & 385 coming off of the 380 leg. can somebody help me with this problem? If I go into manual mode the spindle will operate but none of the axis will operate.  |
|
#2
09-21-2007, 07:12 AM
| |||
| |||
| It sounds like you have a bad BOSCH axis drive board which the control is seeing. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heidenhain tnc 2500 on Interact 308 | GarageShop | Bridgeport and Hardinge Mills | 16 | 12-15-2010 04:57 PM |
| Heidenhain 2500 parameters | Daninwyoming | Bridgeport and Hardinge Mills | 17 | 06-10-2010 12:35 AM |
| Heidenhain TNC 2500 in Interact 308 | GarageShop | Bridgeport and Hardinge Mills | 12 | 08-24-2008 04:16 PM |
| Heidenhain 2500 question | greg b | Bridgeport and Hardinge Mills | 8 | 10-29-2007 03:39 AM |
| Heidenhain 2500 | nycooh | General CNC (Mill and Lathe) Control Software (NC) | 0 | 08-17-2007 02:57 AM |
| | |
Linear Mode
