| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-30-2007, 08:03 AM
| |||
| |||
Does anyone know what kind of signals need to be sent to the NC414 Controllers. I'm goint to be installing this dynomotion card and want to know what I need to send to them. Also does anyone know what the X,Y, and Z command +/- are used for? Any help would be greatly appreciated.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DeskCNC 2nd. gen controller AND HobbyCNC Pro Controller | maycom | DeskCNC Controller Board | 1 | 06-02-2007 02:33 PM |
| Sending Position-Signals over modbus | cnc-freshman | Mach Mill | 0 | 05-07-2007 09:56 PM |
| Multiple Signals on a Cable | cibressus | General Electronics Discussion | 7 | 08-19-2006 06:59 PM |
| parallel port settings/output signals | TMaster | Xylotex | 6 | 04-24-2006 12:16 AM |
| To convert Quadrature Encoder signals to Tachogenerator signals | Babar | General Electronics Discussion | 4 | 02-21-2006 01:05 AM |
| | |
Linear Mode
