Ez Trak Sx Ii - CNCzone.com-The Largest Machinist Community on the net!

tsj3949 · #1 08-25-2007, 04:09 PM

I have an EZ trak sx II mill. After rebooting I am getting an error message stating - Set Parameter (1) failed f4 - error setting Parameter 1.

Does anyone know how to correct this error.

Thank you for you help.

machintek · #2 08-26-2007, 11:04 PM

You are booting from a floppy, if your machine is original.
That means your control is about 14 years old. A lot could be wrong. CMOS and or Cmos battery, Floppy drive, software on floppy,logic power supply, etc.
What is in your control?

George

tsj3949 · #3 08-27-2007, 09:44 PM

Thank you for your reply. I am booting from a harddrive. I asked one of the electricians to check the x and y switches to make sure they were functioning, and they were. I also copied the BMDC.bin file from my second machine and still no change. I will check to find more infomation on the machine.

Thank you again George.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ez-trak	rsbbmw	Bridgeport and Hardinge Mills	6	06-07-2007 03:08 AM
Need help with EZ-Trak SX II	Steve@Reliance	Bridgeport and Hardinge Mills	13	09-26-2006 11:51 AM
BP EZ Trak DX II	smart323232	Bridgeport and Hardinge Mills	8	05-08-2006 02:48 PM
EZ-Trak Plus	DWilliams123	Bridgeport and Hardinge Mills	2	04-28-2006 07:28 PM
EZ-Trak	zdude	Bridgeport and Hardinge Mills	1	10-20-2005 08:32 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)