| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-24-2007, 05:12 PM
| |||
| |||
Hi, I now this forum is for mills , but I didn't see a Hardinge lathe forum, anyway my question is, I have a Hardinge Super Precision HNC with the 8 station turret, I bought the lathe without the controle, has anybody redone one of those and what are the options to run the turret. There is some kind of light emitting LED board under the turret, anybody have scematics for that or what else could be used to give the PLC feedback, as to the position of the turret? I included a pic, see attachmnet. Thanks' Frank    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Does someone know about Hardinge Super Slant Lathe? | dadv2 | General Metalwork Discussion | 5 | 01-29-2009 01:15 PM |
| Hardinge CHNC turret woes | Karl_T | CamSoft Products | 7 | 12-19-2006 04:54 PM |
| Bolt on Turret 'v' VDI Turret | scappini | General Metalwork Discussion | 0 | 07-20-2006 07:59 AM |
| Wiring Scematic | TweekedOut106 | Machine Problems, Solutions , Wireless DNC, serial port | 0 | 01-30-2006 08:43 PM |
| precision servos (digital) vs. precision stepper (<3.6degree step angle) | bennyben | Servo Motors and Drives | 6 | 03-05-2004 11:11 PM |
| | |
Linear Mode
