r2c3 troublewith switch

[Dar]

hi guys I don,t know if i,m in trouble again or still probable the latter.
here is the problem my start and run hi and low speed switch will start on the low side but when you release it it stops. it works ok in high range.
i have looked all over for one . no luck supposidely not supported anywhere.
I don,t want to mess up the front of the mill byinstalling something else.
can this switch be fixed?? i see screws in the back so i think tomorrow i,m going to very carefully take it apart. however there are lots of these mills out there so if anyone knows of a place to get one please let me know
thanks a lot
i know i don,t post to often because usually some one gives the same answer that i would. and then there is the fact that i know very little about cnc.but i,m learning sllloowwly
Dar

[gus]

The switch is an intermittent switch, so if it works once it should be good, look at the wiring or the relay, probably the relay

[Dar]

thanks for the advice Gus. after checking things again the switch was at fault. took it apart and adjusted it. works fine now. i didn,t want to take it apart untill i knew there were none available.
Dar