bridgeport torq cut 30 shot pin

[porkchop21]

i need help resetting the shot pin

i sent my tranny out for a rebuild and now i need to reset the shot pin
does anyone have instructions or a manual page that i could look at online or both
it is in a bridgeport torq cut 30 vmc with a dx32 controller

thanks in advance

[machintek]

The shot pin sits on the bottom of the transmission and locks it in either high or low gear. It is spring loaded and air switched by a solenoid retracts it for shifting. It has a switch to indicate its state to the control.
Since there is nothing to set, I do not understand your question.

George

[porkchop21]

im sorry it wasnt the shot pin it was the trans sw switch that neede to be reset and adjusted i have it all done back up and running

thanks