bridgeport torq cut 30 shot pin - CNCzone.com-The Largest Machinist Community on the net!

porkchop21 · #1 08-07-2007, 06:03 PM

i need help resetting the shot pin

i sent my tranny out for a rebuild and now i need to reset the shot pin
does anyone have instructions or a manual page that i could look at online or both
it is in a bridgeport torq cut 30 vmc with a dx32 controller

thanks in advance

machintek · #2 08-07-2007, 09:00 PM

The shot pin sits on the bottom of the transmission and locks it in either high or low gear. It is spring loaded and air switched by a solenoid retracts it for shifting. It has a switch to indicate its state to the control.
Since there is nothing to set, I do not understand your question.

George

porkchop21 · #3 08-08-2007, 12:21 PM

im sorry it wasnt the shot pin it was the trans sw switch that neede to be reset and adjusted i have it all done back up and running

thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Info on Bridgeport Torq Cut 22 w/ DX 32 or other small machines??	vettespeed	Knee Vertical Mills	17	10-04-2010 06:19 PM
DX32 questions (Bridgeport Torq Cut 22, DX-32, DX 32)	vettespeed	Bridgeport and Hardinge Mills	11	02-03-2007 04:14 PM
Bridgeport DX-32 Torq-cut 22 peck drill problems	RedGTZ	Bridgeport and Hardinge Mills	5	02-02-2007 12:47 AM
Bridgeport Torq-Cut 2G-?????	bherr	Bridgeport and Hardinge Mills	17	10-21-2006 01:56 AM
Bridgeport Torq Cut 22: What lubricants? Where? How?	vettespeed	Bridgeport and Hardinge Mills	5	06-24-2006 02:38 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)