Interact 1 mk2 problem - CNCzone.com-The Largest Machinist Community on the net!

yarpo · #1 08-06-2007, 01:15 PM

Hi, cnc newbie here. I've got a Bridgeport Interact 1 Mk2 mill with TNC2500.
It was purchased at the start of the year from a local company and it's done very little work.
It was working fine when bought but now i've finally got round to using it I can't get it to go.

I get the message "SPINDLE MOTOR FAN OVERLOAD"

Is it a simple fix??

awemawson · #2 08-06-2007, 04:39 PM

Do you have compressed air rigged to the mill? On my Interact (a Mk1) the spindle brake is held off by the air, and if no air present the spindle motor overloads trip and have to be reset.

AWEM

machintek · #3 08-06-2007, 11:39 PM

The Interact 1 Mk2 has a KTK spindle drive. There is a fan on the bottom of the spindle motor. There must be a overload for it. Thus check all the overloads on the machine.

George

yarpo · #4 08-07-2007, 02:12 PM

Yep, you were right!
I found a reset button on one of the cards. Works fine now! Thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bridgeport Interact 412 Tool Changer Problem	RMARCH	Bridgeport and Hardinge Mills	17	05-09-2011 11:57 AM
BP series II Interact 4 tool release problem	bherr	Bridgeport and Hardinge Mills	2	08-05-2007 07:43 AM
Bridgeport Interact 24v DC reg problem	Paul_Leoni	Bridgeport and Hardinge Mills	3	11-14-2006 04:15 AM
Interact 1 MKII 4th axis problem....?	DuncanRitchie	Bridgeport and Hardinge Mills	1	08-22-2006 10:05 PM
Bridgeport Interact 1 MkII problem	sparsrus	Bridgeport and Hardinge Mills	13	05-02-2006 04:53 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)