![]() | |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| This forum is sponsored by: |
![]() |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
| ||||
| ||||
| There is no picture, but from what I would guess is that they have a PCB part and a plug in part that has screw wire termination? If so they come in different pad spacing and terminal count, usually from 2 to 10. Weidmuller, Pheonix Contact, Entrelec and several others make them, I believe Amp also. You should find them in DigiKey Newark or most of the online electronic vendors. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#4
| ||||
| ||||
| Most of the manufacturers use different colours, but Weidmuller is mainly Orange, Phoenix Contact mainly Green and Entrelec Grey. If you can find a Phoenix supplier you can most likely match them up. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Terminal Block | Smackre | General Electronics Discussion | 3 | 11-18-2006 02:34 PM |
| green as they come | SILVERBACK | Industrial Hobbies (Support forum) | 6 | 09-25-2006 07:34 AM |
| So New, I'm as green as a Martian | Micro Rotors | DIY-CNC Router Table Machines | 35 | 09-14-2006 07:22 PM |
| green as grass | jonandyev | Stepper Motors and Drives | 4 | 04-19-2006 02:04 PM |
| terminal #37 | utengineer04 | Bridgeport and Hardinge Mills | 1 | 09-07-2005 02:40 PM |