| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-30-2007, 11:20 AM
| |||
| |||
Hello, I have a BP series II CNC mill (boss 6) with 2 superior motors. and 1 sigma Z motor. I am running geckos 202'2 at 75 VDC is this too much for these motors? The reason I ask is I had one develop a direct short to ground in the sigma motor. The motors dont get hot when the machine is running. I have purchased a used superior.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stepper motor: voltage vs. current ratings | cnczane | DIY-CNC Router Table Machines | 3 | 09-08-2008 12:14 PM |
| Stepper motor speed\voltage question? | cwdance1 | DIY-CNC Router Table Machines | 4 | 03-28-2006 04:26 PM |
| Nema 42 superior electric 820oz motor | sailinon | Stepper Motors and Drives | 3 | 11-17-2005 07:51 PM |
| Stepper motor Voltage | metron9 | Stepper Motors and Drives | 3 | 11-15-2004 07:10 PM |
| Stepper voltage | glentner | General Electronics Discussion | 7 | 03-29-2004 11:02 PM |
| | |
Linear Mode
