BP Series 1 Tera Term problem - CNCzone.com-The Largest Machinist Community on the net!

mellery1 · #1 05-08-2007, 09:28 AM

Hello, I too have just purchased a BP Series 1 Boss 5. I am using Tera Term (dos version) software to edit and transfer my programs. The machine runs great! Occasionally, when transferring the programs, the editor seems to drop a character or two. Mainly its the (N) character starting off the line. Example; N10 X1.500Y1.500F80 Everything will transfer except the (N). Has anyone run across this problem?

keithboggio · #2 04-09-2010, 03:53 PM

I am sorry that I cannot answer your question, but I was wondering if you could answer some of mine?

I just purchased a Bridgeport Series II CNC Machine with Boss 6 RS232 setup and whos to forget the tape deck. I am picking it up next weekend and bringing it home.. I am really hoping to get myself all set up with the software and PC that I need to upload programs into the machine. What kind of software, PC, and operating system are you using?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
BP Series 1 Z-axis problem (BOSS 4)	ABT	Bridgeport and Hardinge Mills	5	04-29-2007 07:32 PM
problem with BP series 1 spindle not working	zoqdi	Bridgeport and Hardinge Mills	0	02-06-2007 03:04 PM
bestline auto feed problem on a series 2	brownandsharp	Bridgeport and Hardinge Mills	2	07-27-2006 05:01 PM
Crusader series M will not boot up pots problem?	RGMJOE	Machine Problems, Solutions , Wireless DNC, serial port	8	03-20-2006 08:12 PM
Parallet and Series transformer Setting problem	weberluk	General Electronics Discussion	5	10-17-2005 11:17 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)