| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-25-2007, 01:48 PM
| |||
| |||
I recently purchased a 1984 Bridgeport R2E3 . I have a question concerning cables for the RS232 connection. I am looking to program with a laptop and would like to connect to the machine via the RS232 connection. Where can I find a good place to buy the cable and the correct adaptor for going into the machine. Thanks in advance for your help......  |
|
#2
04-28-2007, 11:08 PM
| |||
| |||
P.M. jonp he might be able to help he's posted in the BTC clubhouse Good luck Kevin |
|
#3
04-29-2007, 11:09 AM
| |||
| |||
| There was someone on EBAY selling a RS232 cable, software and an adapter to the AMP 8 pin round reverse sex connector. Or you can build your own. The AMP connectors are available at Newark Electronics and such similar places. You only need a 3 conductor, shielded cable (transmit, receive, and signal ground). George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RS232 cable to run onecnc on haas? | turboboy | OneCNC | 5 | 04-17-2008 08:49 AM |
| Help! Dead Series 1 R2E3 battery, need jumper cable? | Bill Gillen | Bridgeport and Hardinge Mills | 4 | 10-12-2006 05:24 PM |
| Fanuc om-d rs232 cable | Julian M | Fanuc | 4 | 09-09-2006 06:41 AM |
| Fanuc om-d rs232 cable | Julian M | General CNC (Mill and Lathe) Control Software (NC) | 2 | 09-01-2006 05:20 PM |
| Bridgeport R2E3 with Boss 8 | John Bennett | Bridgeport and Hardinge Mills | 5 | 04-06-2005 10:06 AM |
| | |
Linear Mode
