| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-16-2007, 11:13 PM
| |||
| |||
Before i get to my new problem, I would like to thank everyone for all the help that I receaved from this forum. Now for the new problem, When I try to enable the spindle nothing happens. I checked all fuses, keypad test, 1st. event log and reseated boards. what next. Steve    |
|
#2
02-17-2007, 12:08 AM
| |||
| |||
| Is Your way oil tank full? Air turned on? Are you holding the other switch to high or low while turning the spindle enable on? George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
02-18-2007, 02:02 AM
| |||
| |||
| George, it was the way oil. Thanks SOH |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bridgeport R2E4 | steve ohalloran | Bridgeport and Hardinge Mills | 11 | 06-21-2010 04:11 AM |
| bridgeport 9 r2e4 | reedmiles | Bridgeport and Hardinge Mills | 4 | 06-22-2007 09:07 PM |
| r2e4 drives | najnielkp | Bridgeport and Hardinge Mills | 0 | 10-23-2006 09:45 AM |
| R2E4 Help | jeep534 | Bridgeport and Hardinge Mills | 2 | 10-14-2006 12:45 PM |
| bridgeport 9 r2e4 | reedmiles | General CNC (Mill and Lathe) Control Software (NC) | 0 | 12-30-2005 09:06 AM |
| | |
Linear Mode
