ezcam software

[Dar]

does anyone know where i can get ezcam for my bp2 r2c3 with heidenhain control that doesn,t cost an arm and leg. if so please let me know
thanks Dar

[NC Cams]

You might be able to get a copy BUT it probably won't run due to dongle protection - if you get a used copy, make sure you get the dongle.

Besides, old versions of Ezcam are not supported anymore - they pretty much force the surrendering of an arm or leg to get an "upgrade".

"Upgrade" is defined as buy a new license if you don't have the original dongle.

[Dar]

thanks nccams maybe i should have stuck with my old mill

[Big Daddy]

Ya know you might be able to find some old EZCam version 6 around still that won’t cost you an arm & a leg! Why? Because it’s so good people are still using it!
I recommend version 6.2.1 or 6.3. I still use my 6.2.1 now it’s been 15 years running! Excellent stuff. But you do have to get the dongle with it or it’s useless. Big daddy

[CNCRim]

EZCAM EZ-Mill/Turn Pro v14.1? anyone have copy of this version.

[Big Daddy]

Ya I think I have a clean copy on my old Windows 98 but no dongle with it.
Big Daddy

[Big Daddy]

It’s a free trial version. I could zip it up and e-mail it. Then after playing with it for awhile you could click on the register software and register the software & pay for it with EZCAM then they’ll send you the dongle (key). Big Daddy

[CNCRim]

Diddy I like to give it a try, send it over at newtexas2006@yahoo.com.

[Big Daddy]

hey NewTexas it's version 14.5 will that still work for you?? Big Daddy

[CNCRim]

I like to have copy.