MDI input for BP Interact 1 Mk2 - CNCzone.com-The Largest Machinist Community on the net!

motorman46 · #1 01-16-2007, 12:50 PM

Could someone tell me how to manually input a single straight line move into Heidenhain TNC151 using ISO commands. I am selecting the MDI mode, but it seems I get either a response of "IMPROPER BLOCK FORMAT" or "KEY NON-FUNCTIONAL" when I try to enter a line.

Regards,

Julian

awemawson · #2 01-18-2007, 01:38 PM

OK I had this problem last year with my Interact 1 / Heidenhain TNC151 and eventually found the solution in one of the manuals, copied it and stuck it inside the tool cupboard door. Guess what - I've just been out to the workshop to find it for you, and the sheet isn't there !!! ...argh. I'll browse a few manuals and see if I can remember what it is.

motorman46 · #3 01-19-2007, 08:23 AM

Thanks Andrew, your help is greatly appreciated.

Julian

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)