| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-02-2007, 07:10 PM
| |||
| |||
I have a BP Interact 1 MK2 with the Heidenhain TNC 151B control. The backup battery died and the controller parameters were lost. After reloading the machine parameters when machining arcs the machine hesitates at the 0, 90, 180, 270 quadrant points. I don't think it did that before I lost the parameters. Is there a parameter that controls this? I am using the ISO machine mode and Surfcam post processor. Regards, Julian  |
|
#2
01-02-2007, 08:45 PM
| |||
| |||
| Yes, there is but I have to get to my office to find out which one. I do not know if I will get to my office this week. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
01-12-2007, 05:29 PM
| |||
| |||
Hi George, Have you had a chance to determine which parameter causes the machine to pause at the quadrants of a circle? Regards, Julian |
|
#5
01-15-2007, 05:21 PM
| |||
| |||
| Thank you George, that took care of it. Julian |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
