Drip feeding your V2XT

[weyland]

Has anyone figured out how to drip feed a V2XT?
Can it be done from the hard drive? How?

I've got a V2XT that I finally got the error on, and need to run the program.

Thanks,

Weyland

[rfdoyle]

I'm assuming you have this taken care of. If not, you should be able to run dnc off of your hard drive. Assuming your mill has one. It's either on the same menu that you enable servos or the next one. Towards the right side. Well, on my V2XT with Boss XT 3.4 control (I think) it's that way.
RD

[rfdoyle]

Sorry, it's on the run menu.

[weyland]

Thanks. Yes, I meant to post an update on this, but forgot.
It's in the run menu and available after hitting "run" (F4).
After that, it's F10 on my machine. "DNC Link".

Best,

Weyland

[5S Dude]

Originally Posted by weyland Thanks. Yes, I meant to post an update on this, but forgot. It's in the run menu and available after hitting "run" (F4). After that, it's F10 on my machine. "DNC Link". Best, Weyland

Hi all, is the DNC Link an option on the V2XT control? I have to currently cut my engraving programs into short stories and run them in batches. Thanks......