| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-19-2006, 05:16 PM
| |||
| |||
Help With TNCremoNt & machine parameters  Can one help we with setting up this software I am unsure what cable configuration is? Also has any one got a set of parameters for the TNC 155B controller ? Any help would appreciated, before I go mad !!!!!!!!!!! Andy  |
|
#2
10-19-2006, 06:49 PM
| |||
| |||
| I have a Bridgeport technican bulletin at the office about RS232 communications to a TNC but back then EZUTLS was used because it was a part of EZCAM. TNCREMO did not exist. I have always used a laptop running a DOS version of PROCOMM to communicate to TNC, FANUC and Bridgeport controls. I need your email address to send you that bulletin. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
10-19-2006, 07:44 PM
| |||
| |||
| Machintek: Thanks from a LOT OF US... I would just like to say THANK YOU. I know that you take a lot of your time and effort to help those with Bridgeports, free of charge...People like you are what makes this a great, professional forum. Adobe (old as dirt ) |
|
#4
10-20-2006, 06:44 AM
| |||
| |||
| Thanks any help would rely be good. My e-mail address is 'sales@amg-engineering.co.uk' Regards Andrew Have just downloaded your bulletin, thankyou for you help. Last edited by Leyland 472; 10-21-2006 at 05:03 PM. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Bridgeport Interact 1 MK2 
Linear Mode
