LinkBack URL
About LinkBacksI just picked up a bridgeport series 1 with heidenhain TNC 151 control that is wired for 440v. Didn't get any manuals with it. Can someone tell me how to wire it for 220v or where i might be able to get a maint. manual for it.
I just picked up a bridgeport series 1 with heidenhain TNC 151 control that is wired for 440v. Didn't get any manuals with it. Can someone tell me how to wire it for 220v or where i might be able to get a maint. manual for it.
If machinemanuals.net does not have a manual, then you will have to keep checking Ebay. I know there are about 3 or 4 transformers that need to be retapped, the spindle motor will need to be rewired for 220 (it is a 220/440 motor), and some fuses will need to be changed as the current will double. If I get to my office in the near future, I will see if I at least have a wiring diagram.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Need your email, I have a wiring diagram. It is for a series 2 but it will work.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
could you send that wiring diagram to me also for the bp series II.
gbshas@aol.com thanks
My email castleville@adelphia.net
Thanks your a life saver.
Eric
Dear Eric !
i have wirring for series 1 , if you still have problems send me email on farzin_sharifi2000@yahoo.com
but usualy you have to change the T1 and T2 input
F.Sharifi
machinetek
hello George i also have a bp 2 r2c3 thats wired for 440 would you please send me a copy. then maybe i can learn to run it
thanks Dar
dcosand57@yahoo.com
Posting Permissions
