BOSS 5 Axis Drive Bridge Rectifier?

[Eric]

Does anyone know what the specs are for the axis drive bridge rectifiers for a BOSS 5 series 1 CNC? I have a shorted bridge rectifier on the X axis and the only numbers on it are:

503860 7627937

I don't think my maintance manual mentions the size, just a part number of 1503860.

If I can't find one, I will probably just swap in a 25A bridge rectifier.

--Thanks
Eric

[machintek]

I was looking at bridges at Radio Shack a few weeks ago for a DAEWOO. They have one that LOOKS like the one used in the BOSS 5 but the PIV is too small. No, I do not have the specs, but I would look for something with at least 100 PIV.

George

[Eric]

I got a new 35A 400V bridge rectifier today and the X axis works just fine now.

[gracloud1]

Where did you get the bridge rectifier. I have one that is gone.

[Eric]

Originally Posted by gracloud1 Where did you get the bridge rectifier. I have one that is gone.

Try Newark Electronics: # 48F1230

International Rectifier # 36MB40A
1.2V, 35A, 400V

[gracloud1]

Do you have an address,phone#/

Originally Posted by Eric Try Newark Electronics: # 48F1230 International Rectifier # 36MB40A 1.2V, 35A, 400V

[keebler303]

International Rectifier is a manufacturer. Most places should be able to get their parts.
here is one.
http://www.digikey.com/scripts/DkSea...40A-ND&Site=US

Matt

[jho5820705]

I just bought one from Newark. Phone Number is 1-800-463-9275, cost $6.54 each.
Jim