boss 6 post processing........
Looking for someone in the Phoenix area to help me with getting my machine to post properly. I have a series 2 boss 6 that is connected to a computer and uses the tera term software to communicate. It does fine for the little programs I hand write but would like to know that it is properly setup to run when I use a cad cam program to chisel out some aluminum. I really don't know where or how to start to get this done. Not looking for freebies or hand outs just some experience that will get the job done for me.
Please email me at email@example.com if you are willing to take this job on so we can discuss how much $ and when it can take place.
I'm in the east valley so I'm not sure if you would have to come here or is it something we can do over the phone or me come to you?
If this request for help seems a little unguided please refer to my forum name!!
Thanks for your support.