Need help where to find CRT Board for R2E4 Mill - CNCzone.com-The Largest Machinist Community on the net!

SUB84 · #1 08-11-2006, 03:45 PM

LOOKING FOR PARTS ON R2E4 (CRT board ) Repair or new ?
Need help where to find CRT Board for R2E4 Mill

Tom Long · #2 10-26-2006, 07:50 PM

Did you find any CRT parts? I have a machine that is being converted and it had a good display and keyboard.

tenmetalman · #3 10-29-2006, 05:29 PM

chip sweeper,
Did you find the CRT board, Do you have a board number and or a picture ? I have a complete working monitor out of a BP Discovery 300. All cards going to the CRT are on the monitor chassis. I removed it and installed a 15" flat screen. It works good but did not have the abilty to show the Mach3 screens. I unplugged everything so it's ready to be plugged back in and be up and run. If your interested, email me at tenmetalman@yahoo.com as my normal mail server is down

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)