Cracked casting? - Page 2 - CNCzone.com-The Largest Machinist Community on the net!

Hood · #13 07-24-2006, 03:07 PM

OK heres the link for the 30 taper, not sure how this would affect the closing of the Ericson system though, if you mail them make sure you tell them its a QC spindle you have.
http://cgi.ebay.com/ws/eBayISAPI.dll..._BIN_Stores_IT

wyobmf · #14 07-25-2006, 11:29 AM

Thanks that looks like a cheap and easy fix, I will contact wells index.
Thanks

Hood · #15 07-25-2006, 11:59 AM

I measured my runout today, only have a metric dial that is long enough to reach into the spindle. It is graduated 0.01mm and there was hardly a flicker on the needle so I can safely say the runout is less than 0.005mm (0.0002")
Hood

wyobmf · #16 07-25-2006, 12:13 PM

That is good compared to mine. I think I will have to get it fixed.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)