| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-26-2006, 02:26 PM
| |||
| |||
a bridgeport with funac control, open the panel, turn on the power, no2 contactor trigger then release, no.1 and no.3 no action(no.1 low speed , no.2 high speed, no.3 switch). can not eliminate the alarm, anybody can help me out. do i need to take the motor out and check it since i cant run it, cant check the current.  |
|
#2
04-26-2006, 03:42 PM
| ||||
| ||||
| Not enough information!! What Fanuc control? is it DC or AC spindle? is it a Fanuc spindle? If so there should be a LED readout on the Spindle controller which will indicate fault. What is the alarm on the screen? Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. |
|
#3
04-26-2006, 10:35 PM
| |||
| |||
| Is the spindle drive Fanuc or Yaskawa? Is it a Fanuc 0M control or a 21iM control? George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
