| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-03-2006, 07:23 PM
| |||
| |||
Whats the differance between Boss,Trac ,etc.etc?I have two Bridgeport series 1 MDI mills."Manual Data Input"They have Heidenhein TNC 131 controls on them.Are they as easy to upgrade as the others?Im also in need of knowing if I can run both of these mills off a rotary phase converter?Thanks Chris  |
|
#2
04-03-2006, 08:44 PM
| |||
| |||
| Your machine was a very limited production MDI machine. You used it as a manual machine and "taught" it what you were doing. It could then run a second part. It has BOSCH drives and SEM servo motors. Any machine can be upgraded. It is a matter of money. Some one that has done an upgrade with this configuration will have to advise you further. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
04-03-2006, 09:03 PM
| |||
| |||
| Thanks for the info.Im open for somebody who has retro fitted one one these. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
