Heid426 cutter comp

[KevinV_MEI]

My post is putting out the following when I enable cutter comp.;

% TEST-CC G70
;
N1 G00 G90 Z0. M91
; 0.744 3/4 FLAT ENDMILL TOOL - 3 DIA. OFF. - 0 G53 P01+1 LEN. - 0 DIA. - .744
N2 T3 G17 S600
N3 M06
N4 G53 P01+1
; BRIDGEPORT VMC1000-HEIDENHAIN 426
; MACHINE GROUP-1
N5 G00 G90 G40 X+19.2461 Y-8.9319 M03
N6 Z+4 M08
N7 Z+1.1
N8 G01 X+19.2461 Y-8.9319 Z+1 F64
N9 G03 G41 X+18.8469 Y-8.5258 I+18.5562 J-9.2106 F200
N10 G01 X-19.2251 Y+7.6348
N11 G03 G40 X-19.7945 Y+7.6398 I-19.5158 J+6.95
N12 G00 Z+4
N13 X+19.2539 Y-8.9135
N14 X+19.2539 Y-8.9135 Z+1.1
N15 G01 X+19.2539 Y-8.9135 Z+1 F64
N16 G03 G41 X+18.8548 Y-8.5074 I+18.5641 J-9.1922 F200
N17 G01 X-19.2173 Y+7.6533
N18 G03 G40 X-19.7867 Y+7.6582 I-19.508 J+6.9684
N19 G00 Z+4
N20 X+19.2617 Y-8.8951


Looking at line 9 on the controller I get an error "comp not in correct order"

Does anyone have an example of a Heidenhain program with cutter comp enabled that works so I can validate the syntax is correct?

Kevin V.