| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-20-2012, 03:16 PM
| |||
| |||
Hi Having a heck of a time getting this mill up and running. X axis was tripping in + direction when doing rapid move, worked fine other direction. Swapped Z axis motor and encoder with X axis motor & encoder. Now I don't know if it's a fluke that this fault just popped up or if it's related. I don't think it's related, but when I go to home all axis now the X axis will move off the home switch then reverse direction and immediately kick axis off line, when it hits home switch again... I should check limit switch maybe as it is normally closed? perhaps it's not making contact?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Dual Y Axis Slave A Axis Homing Problems | guy2b1 | Calibration & Measurement | 4 | 03-03-2012 04:06 PM |
| R2E3 x axis trips in rapid one direction | dougputt | Bridgeport and Hardinge Mills | 12 | 02-08-2012 05:36 PM |
| R2E3 x axis trips in rapid one direction | dougputt | Bridgeport/Romi Lathes | 2 | 01-19-2012 07:59 PM |
| EMC2 axis Z-axis homing and table | satovey | LinuxCNC (formerly EMC2) | 2 | 07-02-2011 04:05 PM |
| lost origin when y axis limit switch trips | timmydabull | Haas Mills | 10 | 04-04-2009 12:44 PM |
| | |
Linear Mode
