Box way. Typically has the Bridgeport control, and Siemens drives and motors. Encoders in the motors for the position loop.
George
Does anyone know these machines?
Good or Bad?
They are all box way, no?
Do they have linear scales on the axis or encoders or resolvers?
What is the brand of the drives/motors?
I am looking at one for possible control retrofit.
Thanks!
Box way. Typically has the Bridgeport control, and Siemens drives and motors. Encoders in the motors for the position loop.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
simple but good
Per service bulletin 376 dated 5/23/64 all vmc760dx32 use siemens digital drive for the spindle. These are Simodrive 611.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)