| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-13-2011, 11:14 AM
| |||
| |||
I'm having a problem with the accuracy of the readout on an EZ Vision Mill, such as I can pick up an edge, make a cut, but it will consistently be about .005 off.... any ideas....anybody....maybe somthin dirty? The mill is only three years old.  |
|
#2
12-13-2011, 06:22 PM
| |||
| |||
| Maybe reader head is loose. Either where it mounts or maybe inside the scale. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- TL2 accuracy problems | garylb | Haas Lathes | 4 | 09-12-2011 04:41 AM |
| CNC accuracy problems | jtriggs | Mach Mill | 20 | 03-24-2009 06:47 AM |
| Dynatorch accuracy problems | totalfab06 | DynaTorch | 14 | 01-30-2008 07:54 PM |
| BP Series I accuracy problems - Centroid controls | turbostang | Bridgeport and Hardinge Mills | 7 | 11-21-2007 11:27 PM |
| Accuracy problems | i228208 | General CAM Discussion | 26 | 05-30-2004 01:31 PM |
| | |
Linear Mode
