Need Help! parameters for a 1988 Bridgeport Interact 412V Heidehnain TNC151 P control - CNCzone.com-The Largest Machinist Community on the net!

RMARCH · #1 11-17-2011, 02:09 PM

Hi , I was wondering if anyone has the machine parameters for a 1988 Bridgeport Interact 412V Heidehnain TNC151 P control . I recently bought the machine and it had problems when i got it. ( I knew this ) I was just looking at the parameter list i got with the machine and it is for the TNC 155 control.
I'm not sure if they are the same or not.

Thanks

gus · #2 11-18-2011, 06:10 AM

i 'think' the parameters for the 155 are extended, for graphics etc, but that the baseline parameters are valid. Look at a manual for the 151 and 155 and confirm that this is the case

RMARCH · #3 11-18-2011, 07:11 AM

HI Gus , Thanks for the Reply !!!! I think it's strange that the parameter list i got with the machine is not a match to the control. I don't think bridgeport would do this.....then again you never know......? I was hoping to find a list for the TNC151 so i could compare them.

jmccracken · #4 12-05-2011, 05:06 PM

Hi ... I've just purchased an 1988 Interact with the Heidenhain TNC 151. Attached are the factory machine parameters.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- bridgeport interact 1 lost parameters	thomasmc	Bridgeport and Hardinge Mills	9	03-29-2012 12:44 AM
Need Help!- Bridgeport interact 412V	jovanov	Bridgeport and Hardinge Mills	0	05-09-2011 06:43 PM
Need Help!- Bridgeport Interact 720 parameters	M.G.Machinist	Bridgeport and Hardinge Mills	3	01-07-2010 06:04 PM
Series 1 Bridgeport w/TNC151 control	Mark Canaan	Bridgeport and Hardinge Mills	5	12-03-2008 03:45 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)