Need Help with Bridge Port - CNCzone.com-The Largest Machinist Community on the net!

Altonjones · #1 11-13-2011, 04:04 PM

Seeking assistance with a Bridge Port Series 2 Milling Machine. It is equipped with a Heidenhain TNC 155 B/TNC 155 Q controller. Bought at auction, back up batteries dead, lost program. Need assistance with reprograming.

machintek · #2 11-13-2011, 10:53 PM

The PLC is on PROMS. You need the parameters. Search the posts.
note that some parameters are generic and some are machine specific (backlash, distance allowed to travel from home switch).

George

machintek · #3 11-13-2011, 10:53 PM

The PLC is on PROMS. You need the parameters. Search the posts.
note that some parameters are generic and some are machine specific (backlash, distance allowed to travel from home switch).

George

gus · #4 11-14-2011, 07:18 AM

I bumped the parameter lists but there is not your machine there

You need to get a manual, any Bridgeport/heidenhain knee mill manual will get you close, but the series 2 has several differences

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Half bridge or Full bridge	bunalmis	General Electronics Discussion	3	04-13-2008 02:11 PM
Bridge Port Series II CNC for sale	PoppaBear10	Bridgeport and Hardinge Mills	7	02-17-2007 02:42 PM
Bridge Port Clone CNC conversion	happymarius	Employment Opportunity	0	01-21-2007 06:56 PM
Bridge port series II NC 1973 Retro help	astro02	Bridgeport and Hardinge Mills	20	01-04-2007 11:30 AM
Bridge Port Textron opreating mannual required..	Danii	Bridgeport and Hardinge Mills	1	08-10-2006 03:43 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)