| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-16-2005, 11:49 PM
| |||
| |||
Hi guys, on my V2XT the housing that contains the " Y " axis tooth belt and pullies had filled up FULL with fluid and rusted the heck out of both big & small pullies. This happend at the place i bought the mill from. Thay are in BAD shape! The mill will run with them but thay NEED replaced. Anyone have these parts and/or where is the place to get them now? thanks mike  |
|
#2
10-17-2005, 06:51 AM
| |||
| |||
| Try calling Hardinge. Do ou have the maintenance manual to get the part numbers? Be aware that there were 2 different versions based upon the shape of the casting for the Y axis drive. One was a rectangle. The other had a "dog leg" shape to one side of the casting. Try calling Alan at 1-800-245-2598. He can adise you of the availability of these parts. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
10-22-2005, 09:38 PM
| |||
| |||
| Try bptpartsrus on Ebay they have a lot of nos parts from the auction . |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
